Knowledgebase
CP30 Firmware and Configuration upgrade using DNP3 File transfer
Posted by Jayashree Dinesh on 18 January 2018 09:18 AM

The CP-30 now supports DNP3 File transfer feature in firmware version 4408 or later. This feature allows users to upgrade the firmware and configuration using the third party SCADA software. The Firmware /configuration file upgrade by DNP3 file transfer can be done though the Ethernet or serial port.

This application note AP 30 describes how to download firmware and configuration files using DNP3 file transfer.

The DNP3 file transfer using Ethernet port is tested and explained using three different DNP3 masters - Top Server, Triangle Microworks and ClearSCADA.

DNP3 file transfer using Serial port is tested and explained using ClearSCADA.

--Tested using Ethernet and serial ports. 
--Tested using secure Authentication. 
--Tested using indirect routing. 
--Tested using serial radios



Attachments 
 
 AP30-CP30- Firmware and Configuration upgrade using DNP3 file transfer.pdf (3.06 MB)
 Clearscada configuration.rar (43.00 KB)
 Topserver configuration.rar (4.88 KB)
 Triangle microworks config.rar (12.75 KB)
 Firmware file transfer tope server.pcapng (15.57 MB)
(0 vote(s))
Helpful
Not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments: